Denon DVD-2200 Instrucciones De Operación página 9

(5) Connecting a basic 5.1-channel surround system
Analog 5.1-channel audio signals can be output from the DVD-2200.
The multichannel audio signals recorded in packed PCM and the multichannnel Super audio CDs can be played
when an AV amplifier equipped with analog 5.1-channel audio inputs is connected.
DVD-2200
If necessary, connect the video terminals, referring to page 6.
Front speaker (left)
Surround speaker (left)
AV amplifier with 5.1-channel
NOTES:
• For multi-channel connections, set "AUDIO CHANNEL" under "AUDIO SETUP" at "SETUP" to "MULTI
CHANNEL" and make the "SPEAKER CONFIGURATION", "CHANNEL LEVEL" and "DELAY TIME" settings.
• The delay time setting is not valid when playing Super audio CDs.
• Set the "SUPER AUDIO CD" setting under "AUDIO SETUP" to "MULTI".
• When playing DVDs recorded in MPEG audio format, the audio signals are down-mixed to 2 channels for
output.
• With the DVD-2200, we recommend turning the digital output off and only outputting analog signals in order
to keep interference from the digital output circuitry to the minimum and allow you to enjoy high bit, high
sampling frequency, high quality multi-channel sound.
To power outlet
Center speaker
Front speaker (right)
Subwoofer
Surround speaker (right)
SURROUND MODE MULTI FUNCTION
DOLBY DTS WIDE 5CH / 7CH DSP MODE FUNCTION CONTROL
DIRECT STEREO SURROUND SURROUND SCREEN STEREO SIMULATION STATUS SELECT
PHONES
INPUT CINEMA / 6.1 / 7.1 VIDEO TONE REC /
MODE ANALOG EXT. IN MUSIC SURROUND ON / OFF DEFEAT M-ZONE 1 M-ZONE 2
INPUT REC SELECT / M-ZONE
input terminals
(6) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See page 18.)
• "DIGITAL OUT" → "PCM"
"LPCM (44.1 kHz / 48 kHz)" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
The same data is output from both digital audio output connectors (COAXIAL and OPTICAL). Connect to one or
the other connector, according to your system.
DVD-2200
75 Ω/ohms pin-plug cable (commercially available)
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to record
Super Audio CDs.
(7) Connecting to a Stereo Component
DVD-2200
If necessary, connect the video terminals, referring to page 6.
NOTE:
• When connecting to a 2-channel audio stereo device, set "AUDIO CHANNEL" under "AUDIO SETUP" at
"SETUP" to "2 CHANNEL" (see page 17). For multi-channel sources, the signals are down-mixed into two
channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
B
Digital audio
input
connector
(COAXIAL)
Optical fiber cable (commercially available)
Stereo component
ENGLISH
8 9
Digital audio input
connector (OPTICAL)
9