avdel Infalok AV 10 Instrucciones página 42

7/8", 1" and 1 1/8" Infalok
03200 and 73410-03300 for Avdel
Fitting Instructions
Item numbers in bold refer to nose assembly components in the table and illustration on pages 7 and 8.
 Lightly coat Jaw Set 5 with Moly Lithium grease.

On a flat work surface, assemble End Cap 8, Cushion 7, Follower 6 and Jaw Set 5 by stacking vertically in that
order.
 The Collet 3 will be supplied pre-assembled with the collar Ejector 2 and jaw Release 4.

Carefully lower Collet 3 over the assembled components, slide to the edge of the work surface and with a finger,
push the assembled components fully inside the collet.
 Holding the tool pointing down, screw the assembled collet fully onto the piston rod until it is flush with end of the collet adaptor.

Insert Collet Lock 9 into Collet 3. Rotate Collet 3 on the piston rod in either direction until Collet Lock 9 slots into
the nearest groove on the collet adaptor. The Collet Lock 9 should be flush with the exterior of Collet 3.

Slide Anvil 1 over Collet 3 and screw into the anvil adaptor until it is firm.

There is a locking 'O' Ring which will create a resistance to the final few turns of the Anvil 1. It is imperative that the
Anvil be hand tightened up against the rear locking face.

Correct installation of the nose assembly can be gauged by the free movement of the correct size pintail through the
assembled jaws in the nose.
18
® Nose Assemblies - 73410-03100, 73410-
®
AV™50 and Avlock T51 Tools