avdel Infalok AV 10 Instrucciones página 35

1/2", 5/8" and 3/4" Infalok
03200 and 73412-03300 for Avdel
Fitting Instructions
 Lightly coat Jaw Set 5 with Moly Lithium grease.

On a flat work surface, assemble Sleeve 8, 'O' Rings 7, Follower 6 and Jaw Set 5 by stacking vertically in that order.

The Collet 3 will be supplied pre-assembled with the collar Ejector 2, jaw Release 4 and with a ball type Collet Lock
9.
 Carefully lower Collet 3 over the assembled components, slide to the edge of the work surface and with a finger,
push the assembled components fully inside the collet.

Holding the tool pointing down, screw the assembled collet fully onto the piston rod until it is flush with end of the
collet adaptor.

Rotate Collet 3 on the collet adapter in either direction until Collet Lock 9 slots into the nearest groove on the collet
adaptor. The Collet Lock 9 should be flush with the exterior of Collet 3.

Slide Anvil 1 over Collet 3 and screw into the anvil adaptor until it is firm.

There is a locking 'O' Ring which will create a resistance to the final few turns of the nose casing. It is imperative
that the nose casing be hand tightened up against the rear locking face.
 Correct installation of the nose assembly can be gauged by the free movement of the correct size pintail through the
assembled jaws in the nose.
® Nose Assemblies - 73412-03100, 73412-
®
AV™30 and Avlock T30 & T40 Tools
11