avdel Infalok AV 10 Instrucciones página 40

3/4" Infalok ® Nose Assembly – Huck 2628 Tool
Fitting Instructions
Item numbers in bold refer to nose assembly components in the table and illustration above.
 Lightly coat Jaw Set 4 with Moly Lithium grease.
 On a flat work surface, assemble Sleeve 6, 'O' Rings 7, Follower 5 and Jaw Set 4 by stacking vertically in that order.

The Collet 8 will be supplied pre-assembled with Collar Ejector 2 and Jaw Release 3.

Place Collet 8 over the assembled stack, slide to the end of the work surface and with a finger push the stack fully
inside Collet 8.
 Screw Collet Adaptor 12 fully into the collet assembly. The shoulder of Collet Adaptor 12 should come into contact
with the rear of Collet 8.

Insert Collet Lock 9 into Collet 8. Unscrew Collet Adaptor 12 until Collet Lock 9 slots into the nearest groove. The
Collet Lock 9 should be flush with the exterior of Collet 8.
Servicing Instructions
Nose assemblies should be serviced at weekly intervals. You should hold some stock of all internal components of the
nose assembly as they will need regular replacement.
Remove the nose assembly using the reverse procedure to the 'Fitting Instructions'.
 Any worn or damaged part should be replaced.
 Clean and check wear on Jaw Set 4.

Check that Collar Ejector 2, Follower 5, Sleeve 6 and 'O' Rings 7 are not distorted.

To remove a damaged or worn Collar Ejector 2 cut at a point between the flange of the ejector and the end of
Collet 8. The Collar Ejector 2 and Jaw Release 3 can then be separated and removed from Collet 8.

When assembling a new Collar Ejector 2 and Jaw Release 3 in Collet 8, first ensure that the threads are clean,
before applying Loctite® 243 and screwing the two parts together within Collet 8.

Assemble according to the 'Fitting Instructions'.
16