avdel Infalok AV 10 Instrucciones página 31

1/2" Infalok ® Nose Assembly – 73433-03200 for Avdel
Fitting Instructions
Item numbers in bold refer to nose assembly components in the tables and diagram above.

Ensure the installation tool piston is in the fully forward position.

Lightly coat Jaws 5 with Moly Lithium grease.

On a flat work surface, assemble the Sleeve 8, 'O' Rings 7, Follower 6 and Jaws 5 by stacking vertically in that
order.

The Collet 3 will be supplied pre-assembled with the Collar Ejector 2, jaw Release 4 and with a ball type Collet Lock
9.
 Place the Collet 3 over the assembly stack, slide to the end of the work surface and with a finger, push the stack
fully inside the Collet.

Holding tool pointing down, screw the assembled Collet 3 onto the Collet Adapter until it is flush with the rear face
of the collet adaptor.

Rotate the Collet 3 on the collet adapter in either direction until the Collet Lock 9 ball slots into the nearest indent
on the collet adapter. The Collet Lock should be flush with the exterior of the Collet.
 Slide the Anvil 1 over the Collet 3 and screw into the body of the tool until it is firm.

There is a locking 'O' ring which will create a resistance to the final few turns of the Anvil 1. It is imperative that the
anvil be hand tightened up against the rear locking face.
 Correct installation of the nose assembly can be gauged by the free movement of the correct size pintail through the
assembled jaws in the nose.
Servicing Instructions
Nose assemblies should be serviced at weekly intervals. You should hold some stock of all internal components of the
nose assembly as they will need regular replacement.
 Remove the nose assembly using the reverse procedure to the 'Fitting Instructions'.

Any worn or damaged part should be replaced.

Clean and check wear on Jaws 5.

Check that the collar Ejector 2, Follower 6, Sleeve 8 and 'O' Rings 7 are not distorted.

To remove a damaged or worn collar Ejector 2 cut at a point between the flange of the ejector and the end of Collet
3. The collar Ejector 2 and jaw Release 4 can then be separated and removed from Collet 3.

When assembling a new collar Ejector 2 and jaw Release 4 in the Collet 3, first ensure that the threads are clean,
before applying Loctite

Assemble according to the 'Fitting Instructions'.
® 243 and screwing the two parts together within Collet 3.
® AV™15
7