avdel Infalok AV 10 Instrucciones página 29

1/2" Infalok ® Nose Assembly – 73432-03200 for Avdel
Fitting Instructions

On a flat work surface, assemble the Sleeve 5, 'O' Rings 6, Follower 4 and Jaw Set 3 by stacking vertically in that
order.
 Place the Collet 2 over the assembly stack, slide to the end of the work surface and with a finger, push the stack
fully inside the Collet.

The Collet 2 will be supplied pre-assembled with a ball type Collet Lock 7.
 Holding tool pointing down, screw the assembled Collet 2 onto the piston rod until it is flush with the rear face of the
collet adaptor.

Rotate the Collet 2 on the collet adapter in either direction until the Collet Lock 7 ball slots into the nearest indent
on the collet adapter. The Collet Lock 7 should be flush with the exterior of the Collet 2.

Slide the Anvil 1 over the Collet 2 and screw into the body of the tool until it is firm.

There is a locking 'O' ring which will create a resistance to the final few turns of the Anvil 1. It is imperative that the
anvil be hand tightened up against the rear locking face.
Servicing Instructions
Nose assemblies should be serviced at weekly intervals. You should hold some stock of all internal components of the
nose assembly as they will need regular replacement.

Remove the nose assembly using the reverse procedure to the 'Fitting instructions'.

Any worn or damaged part should be replaced.
 Clean and check wear on Jaw Set 3.
 Check that the Follower 4, Sleeve 5 and 'O' Rings 6 are not distorted.

Assemble according to fitting instructions.
® AV™15
5