Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
It is important that the installation instructions below are followed for successful installation of this
portable air conditioner. Please call Customer Support if you have any difficulties or queries regarding
these installation procedures.
Installation Kit:
1.
Window Bracket Kit.............................
2.
Window Bracket Panel Adapter...........
3.
Plastic Pin............................................
4.
Hose Connector..................................
5.
Plastic Hose........................................
Installation Steps:
1. Install the plastic hose with window bracket adapter and hose connector on both sides.
Ensure proper fit on both ends.
2. Adjust the window bracket as per width or
height of your window and insert the plastic pins
to fix at the desired position. There is a hole
where the Plastic Hose will be inserted later.
Make sure this hole is not blocked.
Plastic Pin
20" to 47" (50.5cm to 119cm)
Note:
After setting the window bracket to the size of your
window, please remove it from the window and
follow the instructions below.
4. Connect the window bracket to the opposite
end of the plastic hose. Ensure that all
connections are tight and installed properly.
1 Set
1 Piece
2 Pieces
1 Piece
1 Piece
Hole for Plastic Hose
EN
1
2
x 1
x 1
3. Connect the plastic hose to the hose
Connect the plastic hose to the hose
connector on back of the unit. Slide-in the
connector on back of the unit. Push-in until it
hose from right to left until it is locked in place.
is locked in place.
Plastic Hose:
Dia. 5" (12.7cm)
Length: 12" to 47" (30cm~120cm)
5. Connect the window bracket to the window.
6. The Portable Air Conditioner is now ready to use.
3
3
4
x 2
x 1
5
x 1
Tabla de contenido
