Husqvarna 455 Rancher II Manual De Instrucciones página 19

• Remove the knob and remove the clutch cover (chain
brake). Take off the transportation ring.
• Fit the bar over the bar bolts. Place the bar in its
rearmost position. Place the chain over the drive
sprocket and locate it in the groove on the bar. Begin
on the top edge of the bar.
• Make sure that the edges of the cutting links are
facing forward on the top edge of the bar.
• Mount the clutch cover and remember to fit the chain
adjuster pin in the hole in the bar. Check that the drive
links of the chain fit correctly over the drive sprocket
and that the chain is correctly located in the groove in
the bar. Tighten the bar nut with your fingers.
• Tension the chain by turning the wheel down (+). The
chain should be tensioned until it does not sag from
the underside of the bar.
The chain is correctly tensioned when it does not sag from
the underside of the bar, but can still be turned easily by
hand. Hold up the bar tip and tighten the bar nuts with the
combination spanner.
When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check the
ASSEMBLY
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life.
Note: If clutch cover is difficult to remove, tighten bar
nut(s), engage brake and rerelease (an audible click will
be heard if released properly).
–
English 19