Care And Maintenance - Hilti SIW 18T-A Manual De Instrucciones

The Li-ion battery features a charge status LED display. The charge status
is indicated by the LEDs on the battery during charging (please refer to the
section "Li-ion battery charge status"). When the battery is at rest (not in
use), its charge status is indicated by the four LEDs on the battery for a time
of three seconds after pressing one of the battery release buttons.
7.6 Belt hook 8
CAUTION
Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the
operator. The belt hook can also be fitted to the other side of the power tool
for use by left-handed persons.
1. Pull the battery out of the tool.
2. Fit the mounting plate into the guides provided.
3. Secure the belt hook with the two screws.

8 Care and maintenance

CAUTION
Before beginning cleaning, remove the battery from the power tool in
order to prevent unintentional starting.
8.1 Care of insert tools
Clean off dirt and dust deposits adhering to the insert tools and protect
them from corrosion by wiping the insert tools from time to time with an
oil-soaked rag.
8.2 Care of the power tool
CAUTION
Keep the power tool, especially its grip surfaces, clean and free from
oil and grease. Do not use cleaning agents which contain silicone.
The outer casing of the power tool is made from impact-resistant plastic.
Sections of the grip are made from a synthetic rubber material.
Never operate the power tool when the ventilation slots are blocked. Clean
the ventilation slots carefully using a dry brush. Do not permit foreign
objects to enter the interior of the power tool. Clean the outside of the
power tool at regular intervals with a slightly damp cloth. Do not use a spray,
steam pressure cleaning equipment or running water for cleaning. This may
negatively affect the electrical safety of the power tool.
Printed: 27.08.2013 | Doc-Nr: PUB / 5136086 / 000 / 01
en
17