Troubleshooting - Craftsman 151.37214 Manual Del Operador

Problem
Handle not in position.
Mower cutting grass
unevenly..
Mower not mulching
properly.
Mower hard to push.
Mower vibrating at
higher speed

TROUBLESHOOTING

Possible Cause
Handle locks not tightened.
Extension cord not connected
to the mower plug. Extension
cord not connected topower
source.Tripped circuit breaker in
the house.Motor control switch
defective.
Lawn is rough or uneven or
cutting height not set properly.
Wet grass clippings sticking to the
underside of the deck.
High grass, rear of mower housing
and blade dragging in heavy grass,
or cutting height too low.
Blade is unbalanced or bent motor
shaft.
13 ― English
Solution
Tighten handle locking knobs.
Reconnect the cord and use the
cord retainer to keep the cord close
to the motor/blade control.Connect
the extension cord to a live 120V
AC, 60 HZ AC receptacle.
Reset house circuit breaker.
If it trips again, call a qualifi ed
electrician.
Have motor control switch replaced
by a qualifi ed service dealer using
identical replacement part.
Move the wheels to a higher posi-
tion. All wheels must be placed
in the same cutting height for the
mower to cut evenly.
Wait until the grass dries before
mowing.
Raise cutting height.
Balance the blade by grinding
each cutting edge equally. Stop
the motor, disconnect the power
source, and inspect for damage.
Have repaired made by an qualifi ed
service dealer before restarting.