Hama EWS-165 Instrucciones De Uso página 5

6. Operation
ote – Input
N
Hold down the ▲ button (16) or the  button (14) to
select the values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and performs
initial setup.
ote
N
• Initial setup takes approx. 2 minutes.
• During connection, the wireless symbol on the measuring
station will ash (1).
• Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors
and inaccuracies.
• The setup process is completed when the indoor (4) and
outdoor (3) measurement data is displayed.
• The measured value is automatically updated by the base
device about every 45 seconds.
• If the temperature is outside of the measuring range,
--.- (lower than minimum temperature) or --.- (higher than
maximum temperature) will appear on the temperature
display.
• If the base station still does not receive a signal from the
measuring station, press and hold the  button (14) for approx.
3 seconds to start the manual search for th
Display
Display ashing
Displayed continuously
Displayed continuously
ote – Faulty transfer of measured values
N
• In isolated cases, interference - e.g. from a WLAN network,
a computer or a television set - can cause the transfer of
measured values between the measuring station and the base
station to fail.
• In this case, you must resynchronise the stations by brie y
removing the batteries from both stations and reinserting them.
• If the measured values are not transferred again once the
batteries are inserted, replace the batteries with new ones.
• If necessary, select a new location for the base station in order
to avoid possible interference in the future.
4
Search for a signal from the
measuring station
Active
Successful –
signal is being received
Inactive –
no signal reception
6.2. Selecting the channel/other measuring stations
ote
N
• You can install two more measuring stations in addition to
the included measuring station. Ensure that the base and
measuring stations are set to the same channel.
Visit www.hama.com for suitable measuring stations.
• The transmission channel on the supplied measuring station
cannot be changed/set (CH1).
• Press the CHANNEL button (15) repeatedly to set the channel
to that set on the respective measuring station. CH1, CH2 or
CH3 (2) is displayed.
• Select CH1 if you are only using the measuring station supplied.
• The base station now shows the data measured (3) on the
selected measuring station (2).
6.3. Basic and manual settings
Automatic setting using the DCF signal
After the rst time the base station is switched on and
successful transmission is established between the base
station and the measuring station, the clock will automatically
search for a DCF signal. During the search, the wireless
symbol (5) will ash.
Display
Display ashing
No display /
Displayed continuously
Displayed continuously
• If the station still does not receive a signal, press and hold the
▲ button (16) for approx. 3 seconds to start the manual search
for the DCF signal. The wireless symbol (5) will start to ash.
ote – Time settings
N
• The search process takes about 3-10 minutes. If the search
fails, it ends and is repeated at the next clock hour.
• In the meantime you can, however, set the time and the
date manually.
• The clock automatically continues to search for the DCF signal
every hour. If the signal is received successfully, the manually
set time and date are overwritten. The clock automatically
continues to search for the DCF signal every hour. If the signal
is received successfully, the manually set time and date are
overwritten.
Searching for the DCF signal
Active
Inactive –
no signal reception
Successful –
signal is being received