Hama Color EWS-1400 Instrucciones De Uso página 5

• Hang up the base/measuring station using the opening (24/28)
intended for this purpose.
6. Operation
Note
Hold down the + button (18) or the – button (19) to select the
values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station automatically
searches for a connection to the measuring station and performs
initial setup.
Note
• Initial setup takes approx. 3 minutes.
• During connection, the wireless symbol on the measuring
station will flash (2).
• Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors
and inaccuracies.
• The setup process is completed when the indoor (5/6) and
outdoor (1/16) measurement data is displayed
• If the base station still does not receive a signal from the
measuring station, press and hold the SEARCH button (21) for
approx. 3 seconds to start the manual search for the signal.
6.2. Basic and manual settings
Automatic setting using the DCF signal
• After the first time the base station is switched on and successful
transmission is established between the base station and the
measuring station, the clock will automatically search for a DCF
signal. During the search, the wireless symbol (8) will flash.
Display
Display flashing
Displayed continuously Successful – signal is being received
No display
• If the station still does not receive a signal, press and hold the –
button (19) for approx. 3 seconds to start the manual search for
the DCF signal. The wireless symbol (8) will start to flash.
4
Searching for the DCF signal
Active
Inactive
Note – Time settings
• The search process takes about 7 minutes. If the search fails,
it ends and is repeated at the next clock hour.
• In the meantime you can, however, set the time and the
date manually.
• The clock automatically continues to search for the DCF signal
on a daily basis (between 1:00 a.m. and 5:00 a.m.). If the
signal is received successfully, the manually set time and date
are overwritten.
• Press and hold the – button (19) again for approx. 3 seconds to
stop the manual search.
Note – Summer time
The clock automatically switches to summer time.
the display as long as summer time is activated.
(Manual) settings
• Press and hold the – button (19) for approx. 3 seconds to stop
the search for the DCF signal. The wireless symbol (8) goes out
and you can set the time manually.
• Press and hold the MODE button (17) for approx. 3 seconds to
make the following settings one after the other:
• 12/24 hour format
• Time zone
• Hours
• Minutes
• Year
• Month
• Day
• Weekday
• To select the individual values, press the + button (18) or the –
button (19) and confirm each selection by pressing the MODE
button (17).
• Press the MODE button (17) immediately to adopt the set value
displayed and to skip onwards.
• If you do not make an entry for 15 seconds, you automatically
exit setup mode.
Note – Time zone
• The DCF signal can be received over long distances, but
always transmits the current Central European Time in
Germany. Make sure you account for the time difference in
countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in
Germany. This means that you should set +3 for the time
zone. The clock then automatically sets the time to 3 hours
after the DCF signal received or relative to the manually
set time.
appears on