Installation; Troubleshooting; Important Note - Wolf M Serie Manual Del Usuario

Ocultar thumbs Ver también para M Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation

Preparation
Remove and recycle packing materials. Do not discard the
package containing the two screws provided for installation.
Install an anti-tip block against the rear cabinet wall. Verify
the screws are adequately secured and do not penetrate
electrical wiring or plumbing.
Installation
Turn power off to the electrical outlet.
1
2
Slide the left corner of the warming drawer into the
opening. If the electrical supply is located in the open-
ing, plug the power cord into the receptacle. If it is
located in an adjacent cabinet, guide the power cord
through the hole in the cabinet wall. Coil excess power
cord behind or beside the unit.
Slide the unit back into the opening until the trim
3
meets the cabinet front. Avoid pinching the power cord
between the unit and cabinet wall.
Open the warming drawer to full extension. Drill a pilot
4
hole in each mounting hole located at the front on
each side of the unit. Refer to the illustration below.
Mount the warming drawer using the two screws pro-
5
vided.
Turn power back on to the electrical outlet.
6
MOUNTING
HOLE
Mounting hole
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.

Troubleshooting

IMPORTANT NOTE: If the warming drawer does not oper-
ate properly, follow these troubleshooting steps:
Verify electrical power is supplied to the warming
drawer.
Verify proper electrical connections.
If the warming drawer does not operate properly, con-
tact Wolf Factory Certified Service. Do not attempt to
repair the warming drawer. Wolf is not responsible for
service required to correct a faulty installation.
wolfappliance.com | 7
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

E serie

Tabla de contenido