Configuring Your Router's Usb Port (For The Befsru31 Only); Usb Configuration For Windows 98 - Linksys Instant Broadband Serie Manual Del Usuario

Configuring Your Router's USB Port
(for the BEFSRU31 only)
When connecting to the Router through its USB
port, please follow the directions below to config-
ure your PC.
Since your Router acts as a network adapter for your PC, there's no need for
you to install a network adapter for that PC. Just follow the directions below
to enable your PC's USB connection to the Router:
• If you are running Windows 98, continue on this page, below.
• For other Windows operating systems, refer to the appropriate section as
listed in the Table of Contents.
After you finish this configuration, make sure that TCP/IP is
installed on your PC(s). For instructions on installing TCP/IP,
please refer to the Installing the TCP/IP Protocol section.

USB Configuration for Windows 98

You can also connect your Router's USB port to other USB devices besides
USB-ready PCs, such as USB hubs.
1. Start up your PC and insert the driver disk into your floppy disk drive.
2. Windows will display a message saying that it has detected new hardware.
Click Next.
6
Instant Broadband Series
NOTE: USB configuration
only applies to Windows 98,
Millennium, 2000, and XP.
®
EtherFast Cable/DSL Routers
3. Select "Search for the best driver for your device (Recommended)." Click
Next.
4. Select "Floppy disk drives" and click Next to start the search for your driv-
er.
7