Configuring Your Network With The Cable/Dsl Router; Configuring Pcs To Connect To The Cable/Dsl Router - Linksys Instant Broadband Serie Manual Del Usuario

7. After a few seconds, the main Network window will appear. The TCP/IP
Protocol should now be listed.
8. Click OK. Windows may ask for original Windows installation files.
Supply them as needed, e.g., D:\win95, D:\win98, D:\win9x, c:\win-
dows\options\cabs.
9. Windows will ask you to restart the PC. Click Yes.
The TCP/IP Installation is now complete.
Please continue on to the next section
to configure your network.
16
Instant Broadband™ Series
®
EtherFast Cable/DSL Routers
Configuring Your Network with the
Cable/DSL Router

Configuring PCs to Connect to the Cable/DSL Router

Now you may have to configure your other PCs to accept the IP addresses that
your Router will provide. If you have not set a static IP or dynamic IP address,
please follow below. Otherwise, skip to the next section titled Configuring
Your Cable/DSL Router.
N N o o t t e e : : Make sure that a network card or adapter has been successfully
installed in each PC you plan to configure before continuing.
These instructions apply only to Windows 95, 98, and ME machines. For
TCP/IP setup under Windows NT or 2000, see your Windows NT, 2000 or XP
documentation.
1. Click the Start button,
select Settings, then
Control Panel.
2. Double-click on the
Network icon.
3. In the Configuration win-
dow, select the TCP/IP pro-
tocol line associated with
your network card/adapter.
If there is no TCP/IP proto-
col line listed for your
card/adapter, go to the
Installing the TCP/IP
Protocol section to install
the TCP/IP protocol now.
17