Important; Brush Speed Selector; Brush Indicator - Hoover SteamVac Manual Del Propietário

2.10 Unlatch back part of tank lid and remove lid.
Empty tank. Pour dirty water out from the rear of the
tank (F).
The lid replaces in a hinge-like manner. Position the
front of lid under tabs (G) on front of tank. Rotate lid
down onto tank. Make sure that the lid is secure on
all sides before placing tank on cleaner.

IMPORTANT

For full suction, it is important that the Dirty
Water Tank lid is properly secured before
cleaning.

brush speed seleCtor

Your SteamVac ® carpet cleaner has three agitator
brush settings.
Hl - for normal cleaning of carpet and bare floors
lo - for gentle cleaning of carpets and bare floors
oFF - for cleaning carpets and bare floors when
brushing is not desired. (See "Picking Up Spills"
section on page 11.)
Slide selector button to the desired setting before
cleaning.

brush indiCator

2.12 The brush indicator will spin (F) when the
carpet cleaner is turned ON and the brushes are
rotating.
If the indicator does not spin and the pattern is
visible (G) when the carpet cleaner is turned ON,
the brushes are not rotating.
There are three reasons why the brushes may not
be rotating:
1. Brush speed selector set on OFF
(see previous section).
2. Solution tube connected (Available on select
models only) (Fig. 4.5).
3. Brush indicator screen dirty.
2.13 To clean screen (H), turn carpet cleaner off and
disconnect from electrical outlet.
Remove clear cover and wipe off screen with a
damp cloth. Snap cover back into position.
2.10
2.11
2.12
F
G
9
Actual model may vary from images shown.
F
2.13
H
G