Storage; Lubrication; Troubleshooting - Hoover SteamVac Manual Del Propietário

storaGe

before storing:
• Empty Clean Water Solution Tank and rinse thoroughly with clean water.
• Replace empty Clean Water Solution Tank and turn carpet cleaner ON. Squeeze trigger and push
carpet cleaner forward and back several times to expel any solution remaining in the carpet
cleaner's system. (Do not use carpet cleaner on wood floors.)
• Empty Dirty Water Tank and rinse thoroughly with clean water.
Allow brushes and underside of carpet cleaner to air dry thoroughly before storing carpet cleaner on a
carpeted or wood surface.
Do not store carpet cleaner with a full Clean Water Solution Tank in place.

lubriCation

The motor is equipped with bearings that contain sufficient lubrication for the life of the motor. The addition
of lubricant could cause damage. Therefore, do not add lubricant to motor bearings.
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug cleaner before servicing.
probleM
Cleaner won't run. 1. Not firmly plugged in.
low suction.
Clean Water
Solution Tank
won't dispense.
brushes/brush
indicator won't
rotate during floor
cleaning.

6. troubleshootinG

WARNING
!
possible Cause
2. No voltage in wall plug.
3. Blown fuse or tripped
breaker.
1. Dirty Water Tank full/
automatic shut off engaged.
2. Blockage In tool on end of
hose.
3. Dirty Water Tank lid not on
correctly.
4. Dirty Water Tank front panel
not replaced after stair or
upholstery cleaning.
1. Clean Water Solution Tank
not firmly in place.
2. Clean Water Solution Tank
empty.
3. Dirty Water Tank lid not on
correctly.
4. Pump needs to be "primed"
(when using tool).
1. Indicator screen dirty.
2. Speed selector on OFF.
!
possible solution
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse or reset breaker in home.
1. Remove and empty Dirty Water Tank.
2. Remove tool and clear blockage.
3. Make sure lid is on securely (p.9).
4. Replace Dirty Water Tank front panel (p.8).
1. Make sure tank is securely locked in
position.
2. Refill tank according to instructions for
surface being cleaned.
3. Make sure lid is firmly in place.
4. See "Before Using Tool" section.
1. Remove clear cover over indicator and clean
screen; replace cover.
2. Move speed selector to Low or Hi.
18