F - End Of Use And Switching Off; G - Maximum Level Of Recovery Water; Draining The Recovery Water - Ghibli & Wirbel ROUND 45 SM 55 TOUCH Uso Y Mantenimiento

Ocultar thumbs Ver también para ROUND 45 SM 55 TOUCH:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79

8.1.f - End of use and switching off

(Fig. 9-13)
-
At the end of the cleaning operations,
before turning the machine off, interrupt
water dispensing and brush rotation by
acting on button (46 Fig. 9).
-
Lift up the brush by pressing the pedal
(19 Fig. 13) as far as it will go, fitting it in
the designated slot.
-
Continue with the aspirator inserted to
aspirate all the liquid on the floor, then
turn off the aspirator by pressing the but-
ton (48 Fig. 9).
-
Lift the squeegee (11 Fig. 13) by lifting
the lever (3 Fig. 13).
WARNING:
Always lift the wiper and the end piece
after finishing the cleaning operations be-
cause this avoids the deformation of the
rubber blades and of the brush hairs.
-
Turn selector (43) to "OFF" to switch the
machine off.
WARNING:
If the machine will not be used for a few
days, it is recommended to disconnect
the plug (35 Fig. 8) from the relative sock-
et.
8.1.g -
Maximum level of recovery
water
If the suction unit turns off while using the
machine, it means that the level of liquid in-
side the recovery tank has reached its maxi-
mum level.
Go to the water drainage station and drain
the recovery tank as shown in the relative
paragraph.
NOTE:
For the proper operation of the level sensors
it is required to properly clean the inside of
the tank (14 Fig. 16).
9.1 DRAINING THE
RECOVERY WATER
At the end of the washing cycle or when the
recovery water tank (14) is full, it is neces-
sary to empty the tank by proceeding as fol-
lows:
NOTE:
To dispose of the recovery water, comply
with the standards in force in the country in
which the machine is used.
-
Position the machine near to a drain out-
let.
-
Disconnect the hose (12) from the sup-
port.
-
Remove the cap (52) from the hose (12)
and drain all the water contained in the
tank.
NOTE:
The amount of water that comes out can be
modulated by pressing on the end of the tube
(12).
-
Put the cap (52) back on the hose (12)
and reposition it on the relative support.
EN - 10
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
(Fig. 14)
Tabla de contenido
loading

Este manual también es adecuado para:

Round 45 sd 55 touchRound 40 sm 55 touch

Tabla de contenido