ton "
" (47 Fig. 9) to prepare water
supply.
Brushes rotation and water supply start
when the accelerator pedal is pressed
with forward or backward motion, or if the
machine is off and the potentiometer (30
Fig. 9) turned on "0".
The gear selector must be always en-
gaged.
Washing, brushing, drying cycle:
-
Press the button "
pare water supply;
-
press the button "
brushes rotation is prepared which start
when pressing the accelerator pedal with
forward motion engaged;
-
press the button "
aspirator starts.
10.1.c - Using the machine (Fig. 9)
DANGER:
Be extremely careful when using the ma-
chine on ramps in order to avoid roll over
or situations which may cause the ma-
chine to lose its balance.
DANGER:
Avoid sudden sharp turns. Turn the wheel
from lock to lock only at low speed, al-
ways considering ground conditions.
-
After having started the machine and
chosen the type of cycle, select the de-
sired movement direction using the se-
lector (31 Fig. 9).
-
Turn on the rotating flash lights (10 Fig. 1)
and the operating lights (9 Fig. 1).
-
Use the accelerator (7 Fig. 10) to begin
the cleaning operations.
NOTE:
Release the accelerator to stop the rotation
of the brushes and the dispensing of water.
" (47 Fig. 9) to pre-
ON/OFF
" (43 Fig. 9),
" (40 Fig. 9), the
EN - 16
Professional Cleaning Machines Since 1968
NOTE:
Proper floor cleaning and drying is performed
by driving the machine forwards. When driv-
ing in reverse, the squeegee is raised and
the suction unit, for removing the water from
the floor, is deactivated.
-
Adjust the washing solution quantity with
the button "
sary.
-
Check the charge status of the batteries
on the display (38 Fig. 9).
NOTE:
When the operator gets out of the machine
the parking brake automatically activates.
DANGER:
It is forbidden to park the machine on
ramps.
10.1.d - End of use and shutdown
(Fig. 9)
-
Once all of the cleaning operations have
been completed, shut off, in sequence,
the rotation of the brushes and the suction
unit, using the relative controls according
to the type of cycle being employed.
-
Turn the key (29 Fig. 9) to its "OFF" posi-
tion.
-
The parking brake automatically acti-
vates.
-
Empty and wash out the recovery tank
and the solution tank as indicated in the
relative sections.
www.ghibliwirbel.com
" (48 Fig. 9) if its neces-