H - Cleaning The Suction Filter; I - Replacing The Fuses; L - Wiper Adjustment; M - Battery Charger And Digital Instrument Configuration - Ghibli & Wirbel ROUND 45 SM 55 TOUCH Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968

10.1.h - Cleaning the suction filter

(Fig. 20)
- Lift the filter with its cover (67).
- Loosen the screw (68) and remove the
filter (69).
- Wash the filter (69) in running water and
reassemble it in reverse order.

10.1.i - Replacing the fuses

(Fig. 21-22)
WARNING:
Replace the blown fuse with one with the
same amperage.
- Remove the plug (35) from the socket
(39).
- Remove the lid (70) by loosening the
screws (71) in order to access the board.
- Unscrew the knobs (72) and remove the
lid (73).
Fuse (74) - 30A
Traction protection.
Fuse (75) - 50A
General board fuse.
Fuse (76) - 75A
Battery fuse.
- Put the cover (73) back on.
- In order to replace the fuse on the posi-
tive pole of the battery, do the following:
WARNING:
Check for the recovery tank to be empty.
- Disconnect the plug (35).
- Press the button (36 Fig. 6) and lift the
tank (14 Fig. 6) until completely over-
turned, then replace the fuse (75 Fig. 6).
10.1.l - Wiper adjustment (Fig. 23)
- It is possible to adjust the height of the
wiper and adjust the incidence of the
blades on the floor.
Height adjustment
The wiper can be height adjusted using the
plates/shims placed on the wiper wheels
(82).
- Loosen the knob (81).
- Lift the support (80) and place the
plate (80a) over or under the plate (80)
according to whether you want to lift or
lower the wiper.
- Tighten the knob (81).
NOTE:
This operation must be performed on both
wheels (82) equally.
Incidence adjustment
- Lower the wiper, using the lever.
- Start the aspirator and proceed for a few
metres, then turn off the aspirator and
stop the machine.
- Check the incidence of the rubber (56)
blades.
Fig. A = too low
Fig. B = too high
Fig. C = correct position
- Use the grey knob (79) for adjustment,
turning it anticlockwise to increase the
incidence and in the other direction to de-
crease it.
10.1.m - Battery charger and digital
instrument configuration
(Fig. 24)
WARNING:
The machine leaves production with a
standard configuration for operation with
"Sonnenschein" gel batteries.
WARNING:
Disconnect the battery plug from the
socket.
- Remove the cover (70) by unscrewing
the screws (71).
EN - 13