3M DBI SALA 3101430 Manual De Instrucciones página 18

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
6.0 MAINTENANCE, SERVICE, AND STORAGE
6.1
CLEANING: Cleaning procedures for the SRD are as follows:
Periodically clean the exterior of the SRD using water and a mild soap solution. Position the SRD so excess water can
drain out. Clean labels as required.
Clean the Lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat. The
lifeline should be dry before allowing it to retract into the housing. An excessive buildup of dirt, paint, etc., may
prevent the lifeline from fully retracting back into the housing causing a potential free fall hazard.
6.2
SERVICE: SRDs are not repairable. If the SRD has been subjected to fall force or inspection reveals an unsafe or
defective condition, remove the SRD from service and discard (see "Disposal").
6.3
STORAGE/TRANSPORT: Store and transport SRDs in a cool, dry, clean environment out of direct sunlight. Avoid areas
where chemical vapors may exist. Thoroughly inspect the SRD after any period of extended storage.
6.4
DISPOSAL: Dispose of the SRD if it has been subjected to fall arrest forces or inspection reveals an unsafe or defective
condition. Before disposing of the SRD, cut the lifeline in half or otherwise disable the SRD to eliminate the possibility of
inadvertent reuse.
7.0 LABELS
Figure 19 illustrates labels on the Self-Retracting Devices and their locations. All labels must be present on the SRD. Labels must
be replaced if they are not fully legible. Pictograms on the labels are defi ned as follows:
Read instructions.
1
One user maximum.
2
Inspect locking action of SRD.
3
Store indoors.
4
Correct way of connecting SRD to harness.
5
Always allow the lifeline to recoil back into the SRD under control.
6
Maximum capacity 141 kg.
7
Temperature usage range -40°C + 60°C
8
May be connected to an anchorage point above, below, or level with the dorsal D-Ring (141 kg maximum).
9
Do not remove label.
10
Do not repair.
11
Visually inspect unit.
12
Edge certifi ed.
13
Do not place the SRD housing on an edge during use.
14
XX = Year Manufactured
1
YY = Heat Lot/Batch Code
2
A
B
18
Tabla de contenido
loading

Tabla de contenido