Product Safety; You Should Pay Attention To This - Kollmorgen MKD-C Manual Del Usuario

MKD Product Safety Guide | 1 English

1.2 Product Safety

1.2.1 You should pay attention to this

Specialist staff required!
Only properly qualified personnel are permitted to perform such tasks as transport, install-
ation and setup. Qualified specialist staff are persons with expertise in transport, installation,
assembly, commissioning and operation of electrotechnical equipment.
Transport, storage, unpacking: only by personnel with knowledge of handling elec-
trostatically sensitive components.
Mechanical installation: only by personnel with mechanical expertise.
Electrical installation: only by personnel with expertise in electrical engineering.
Basic tests / setup: only by personnel with expertise in electrical engineering and drive
technology.
The qualified personnel must know and observe ISO 12100 / IEC 60364 / IEC 60664 and
national accident prevention regulations.
Read the documentation!
Read the available documentation before installation and commissioning. Improper handling
of the devices can cause harm to people or damage to property. The operator of systems
using the drive system must ensure that all personnel who work with the drive read and under-
stand the manual before using the drive.
Check Hardware Revision!
Check the Hardware Revision Number of the product (see product label). Hardware Revsion
Number of MKD-C and MKD-N can differ from each other. This number is the link between
your product and the manual. The product Hardware Revision Number must match the Hard-
ware Revision Number on the cover page of the manual.
Pay attention to the technical data!
Adhere to the technical data and the specifications on connection conditions. If permissible
voltage values or current values are exceeded, the devices can be damaged. Unsuitable
motor or wrong wiring will damage the system components. Check the combination of drive
and motor. Compare the rated voltage and current of the units.
Perform a risk assessment!
The manufacturer of the machine must generate a risk assessment for the machine, and take
appropriate measures to ensure that unforeseen movements cannot cause injury or damage
to any person or property. Additional requirements on specialist staff may also result from the
risk assessment.
The manufacturer should define periodic checks of the electrical components and applic-
ation.
Automatic Restart!
The drive might restart automatically after power on, voltage dip or interruption of the supply
voltage, depending on the parameter setting.
Risk of death or serious injury for humans working in the machine.
If the parameter DRV.ENDEFAULT for one MKD-N is set to 1, then place a warning sign to
the machine (Warning: Automatic Restart at Power On) and ensure, that power on is not pos-
sible, while humans are in a dangerous zone of the machine. In case of using an under-
voltage protection device, you must observe EN 60204-1:2006 chapter 7.5 .
6 Kollmorgen | kdn.kollmorgen.com | July 2019