Removing Stainless Steel Front Panel From The Freezer Compartment Drawer; Aligning The Appliance - Thermador T36IT71FN Instrucciones De Instalación

10. Removing stainless steel front panel
from the freezer compartment
drawer

Loosen and unscrew nuts on the top of the door.
However, do not turn the threaded bolts, otherwise
the door will no longer be aligned.

Do not loosen the screws on the left and right fixing
brackets. Do not unscrew the screws!

Pull the bottom of the stainless steel front panel away
from the door to remove the fixing brackets from the
screws. Then lift the door off the threaded bolts.

Place fixing brackets only loosely into the plates.
Ensure that you do not lose them.

Remove base panel from the appliance.
18

11. Aligning the appliance

m
CAUTION
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– If using a wooden beam as an alternative anti-tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.

Align the appliance with the furniture fronts.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front: with open-ended wrench
5
Rear: with / " (8 mm) hex nut driver via flexible shaft.
16
A mark is attached to the appliance base and is used as a
standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
floor.
m
1
/ " (SW13)
2
1
/ " (32 mm) above the
4