Grundig GWN 39230 R Manual Del Usuario página 82

Machine directly discharges the water it takes in.
• Draining hose might not be at adequate height. >>>
hose as described in the operation manual.
No water can be n in the machine during washing.
• The water level is not visible from outside of the washing machine. This is not a
failure.
Loading door cannot be opened.
• Door lock is activated because of the water level in the machine. >>>
water by running the Pump or Spin programme.
• Machine is heating up the water or it is at the spinning cycle. >>>
programme completes.
• Child lock is engaged. Door lock will be deactivated a couple of minutes after the
programme has come to an end. >>>
the door lock.
• Loading door may be stuck because of the pressure it is subjected to. >>>
the handle and push and pull the loading door to release and open it.
Washing takes longer than the specified in the manual.(*)
• Water pressure is low. >>>
water to prevent poor washing quality due to the decreased amount of water.
Therefore, the washing time extends.
• Voltage might be low. >>>
results when the supply voltage is low.
• Input temperature of water might be low. >>>
extends in cold seasons. Also, washing time can be lengthened to avoid poor
washing results.
• Number of rinses and/or amount of rinse water might have increased. >>>
Machine increases the amount of rinse water when good rinsing is needed and
adds an extra rinsing step if necessary.
• Excessive foam might have occurred and automatic foam absorption system might
have been activated due to too much detergent usage. >>>
amount of detergent.
Programme time does not countdown. (On models with display) (*)
• Timer may stop during water intake. >>>
the machine takes in adequate amount of water. The machine will wait until there
is sufficient amount of water to avoid poor washing results due to lack of water.
Timer indicator will resume countdown after this.
• Timer may stop during heating step. >>>
the machine reaches the selected temperature.
• Timer may stop during spinning step. >>>
system might be activated due to the unbalanced distribution of the laundry in
the drum.
Programme time does not countdown. (*)
• There might be an imbalance of laundry in the machine. >>>
detection system might be activated due to the unbalanced distribution of the laundry in
the drum.
82
Wait for a couple of minutes for deactivation of
Machine waits until taking in adequate amount of
Washing time is prolonged to avoid poor washing
Timer indicator will not countdown until
Timer indicator will not countdown until
Automatic unbalanced load detection
Connect the water draining
Required time to heat up the water
Use recommended
Automatic unbalanced load
Drain the
Wait until the
Grab