Connecting To The Drain; Adjusting The Feet - Grundig GWN 39230 R Manual Del Usuario

• Open the taps completely after
making the hose connection
to check for water leaks at the
connection points. If any leaks
occur, turn off the tap and
remove the nut. Retighten the nut
carefully after checking the seal.
To prevent water leakages and
damages caused by them, keep
the taps closed when the machine
is not in use.

Connecting to the drain

• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
A
WARNING: Your house
will be flooded if the hose
comes out of its housing
during water discharge.
Moreover, there is risk
of scalding due to high
washing temperatures! To
prevent such situations and
to ensure smooth water
intake and discharge of the
machine, fix the end of the
discharge hose tightly so
that it cannot come out.
• The hose should be attached to a
height of at least 40 cm, and 100
cm at most.
• In case the hose is elevated after
laying it on the floor level or close
to the ground (less than 40 cm
above the ground), water discharge
becomes more difficult and the
laundry may come out excessively
wet. Therefore, follow the heights
described in the figure.
58
• To prevent flowing of dirty water
back into the machine and to
allow for easy discharge, do not
immerse the hose end into the
dirty water or do not drive it in the
drain more than 15 cm. If it is too
long, cut it short.
• The end of the hose should not
be bent, it should not be stepped
on and the hose must not be
pinched between the drain and
the machine.
• If the length of the hose is too
short, use it by adding an original
extension hose. Length of the
hose may not be longer than 3.2
m. To avoid water leak failures,
the connection between the
extension hose and the drain
hose of the product must be fitted
well with an appropriate clamp as
not to come off and leak.

Adjusting the feet

A
WARNING: In order to
ensure that the product
operates more silently
and vibration-free, it must
stand level and balanced
on its feet. Balance the
machine by adjusting the
feet. Otherwise, the product
may move from its place
and cause crushing and
vibration problems.
• Loosen the lock nuts on the feet
by hand.