Philips SBC LI 805 Modo De Empleo página 5

XP SBC LI 805 24-06-2002 09:06 Pagina 5
1 Place the receiver in front of the equipment you want to control.
2 Connect the adapter supplied to the receiver and connect the adapter to
R
DC 9V
1 Connect the extension cord to the receiver and position the receiver
R
DC 9V
2 Remove the adhesive tape from the IR light(s) and affix the IR light(s) on
TUNER
TUNER
CD CD
DVD DVD
• Do not use the receiver in moist places or close to water.
• Do not expose the receiver to extreme heat or light.
• When cleaning the receiver, first disconnect from the mains supply. Rub it
with a dry or slightly moist towel, never use excessive amounts of water
on the unit.
Contents
Helpline 2
General 4
Important information 4
Installation 5
Operation 6
Troubleshooting 7
Installation
Receiver -
fig. 1b
The receiver should be facing the equipment with its front window, or with
its back; the receiver is able to transmit IR signals through its dark rear side.
the mains supply (230-240 VAC).
> The green light will light up in the window on the front.
Extension cord -
fig. 2
beside or behind the equipment you want to control.
the IR sensor(s) of the equipment you wish to control.
Notes:
– For the location of the IR receiver(s) on your equipment, check the appropriate
manuals.
– If the location of the IR receiver(s) is not exactly known you can place the IR
lights 5-10 cm away from the front of the equipment you wish to control.
ENGLISH
5