Honeywell Prestige SD Guía De Instalación Del Sistema página 10

Prestige™ Installation Guide
Link remote control to thermostat (optional)
WIRELESS SETUP
Press to link to
another thermostat
YES
CONNECT MORE?
Link outdoor sensor to thermostat (optional)
Press and release
CONNECT
Press to save
and exit
NO
1 Make sure the thermostat displays
the "Add Device" timer (see page 9).
2 Press
CONNECT
be a short delay as the remote seeks
a signal from the thermostat.
3 When the screen displays
"Connected," press
4 Press at the next screen to save
NO
and exit. (Or press
steps 1-4 to link another thermostat.)
The linking procedure at the remote may time
out if there is no keypress within 30 minutes.
To begin again, press and hold the blank
space (or arrow if present) in the lower right
corner of the screen until the display changes
(about 3 seconds).
1 Make sure the thermostat displays
the "Add Device" timer (see page 9).
2 Press the
CONNECT
of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
10
at the remote. There will
.
DONE
and repeat
YES
button on the back