Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Leveling your washer
Excessive noise and vibration can be prevented by properly
leveling the washer.
1 For free standing installation and with the washer within
4 feet (1 m) of its fi nal location, place a level on top of
the washer.
2 Use adjustable pliers to adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable
corner-to-corner.
3 Press down on alternate corners and sides and feel for
the slightest movement. Adjust the appropriate leg(s)
so the washer sits solidly on the fl oor on ALL four legs.
Keep the leveling leg extension at a minimum for best
performance of the washer.
NOTE
For pedestal installations, see additional installation
instructions included with the pedestal.
Connecting inlet water
1 Run some water from the hot and cold faucets to fl ush
the water lines and remove particles that might clog the
water valve screens and to determine which faucet is hot
and which is cold supply.
2 Look in the end of each water supply inlet hose and
verify that the rubber washers are in place.
RUBBER WASHERS
MUST BE PRESENT
NOTE
HOT and COLD water inlet hoses are color coded for
identifi cation. The HOT inlet hose is marked with a RED band
and the COLD inlet hose is marked with a BLUE band.
3 Connect the HOT inlet hose to the HOT water supply and
the COLD inlet hose to the COLD water supply. Tighten
by hand until snug. Then tighten each supply connection
another 2/3 turn with pliers. Do not bend, kink or pinch
water inlet hoses.
4 Turn on the water and check for leaks.
Installation Instructions
a
c
a
c
9
b
lower
raise
d
b
d
Capítulos
Tabla de contenido
