Maintenance; Troubleshooting - Parkside PHD 135 D3 Traducción Del Manual De Instrucciones Origina

2. Remove the seal in the thread of the quick
connector.
✔ You can remove the filter.
3. Clean the filter under running water.
4. Fit the quick connector with filter insert in the
opposite order.

Maintenance

The device is maintenance-free.

Troubleshooting

Problem
Device does not work
Device does not convey wa-
ter
No pressure in device
Water system leaky
Strong pressure fluctuations Standard Vario nozzle (17)
Possible cause
On/Off switch (2) turned
off
No mains power supply
Incorrect voltage supply
Air locks in the pressure
washer
Air locks in the pressure
washer
Pressure loss in line
Connections not correctly
installed
Water connection (21)
leaky
soiled
Standard Vario nozzle ( 17)
blocked
Troubleshooting
Check the On/Off switch
Check the socket, mains connection cable,
plug and fuse and have them repaired by
a qualified electrician if necessary.
Check whether the electrical system
matches the information on the type plate
Turn the device on and activate the pistol
grip (1).
Bleeding, p. 56
Bleeding, p. 56
Check the water supply
Turn off the device and disconnect it from
the mains. Reconnect the device to the
water supply (see Setting up, p. 53)
Turn off the device and disconnect it from
the mains. Replace the water connection
coupling (20) incl. sealing ring (see Spare
parts and accessories)
Rinse the standard Vario nozzle (17)
with water. If required, clean the nozzle
bore hole with a needle (see Cleaning,
p. 56).
Remove the standard Vario nozzle (17)
and ensure that the water can discharge
from the pistol grip (1) unimpeded.
GB MT
57