Installation - Kruger KKH20015CP Manual Del Usuario

KH14011CP/KH17013CP/KH20015CP
1) Connect the high pressure hose to the outlet connection (A) tightening
the metal ring completely, and the other end to the automatic gun (D).
2) Fill the tank with fuel oil through opening (E) and detergent through
opening (F).
WARNING: The machine does not work if the fuel reservoir is not filled
with at least 6 litres of gas oil (Diesel).
WARNING: fuel tank cannot hold more than 20 L of Diesel. Consider the
"DIESEL LEVEL"
3) If the mains voltage corresponds (Volt/Hz ) to the indications on the label
fixed on the motor, you can plug the unit in (C). It is prohibited to use
extensions or loose plugs not to standards. The electrical system the
appliance is connected to must be made in conformity with the laws in
force in the country of installation. It is recommended to have a
differential thermo magnetic switch, with sensitivity equal to 30 mA,
upstream from the power socket.
4) Connect the water supply pipe (diameter not lower than 14 mm) to the
pump inlet connection (B). Make sure that the suction filter of the suction
hose connection is always clean. The dirty filter causes a bad water
supply and consequently a bad pump operation with the inevitable risk of
rapid wearing out and breakage of internal mechanisms.
For three phases engines please check the phase rotation.
B
WARNING:
The earth connection is
compulsory.

INSTALLATION

D
C
A E
Diesel-oil for vehicle only
24
WARNING