Installation - Kruger KH1510F Manual De Uso Y Manutención

4) If the mains voltage corresponds to the indications on the label fixed
on the motor, you can plug the unit in. It is prohibited to use
extensions or loose plugs not to standards.
The electrical system the appliance is connected to must be made in
conformity with the laws in force in the country of installation.
It is recommended to have a differential thermomagnetic switch, with
sensitivity equal to 30 mA, upstream from the power socket.
This is, at 50Hz:
According to sub-clause 2.2.2 of EN 61000-3-11:2000 the apparatus
meets the standard if connected to user's supply with the following
maximum permissible system impedance:
• Zneutral 50Hz = 0.024W
• Zphase 50Hz = 0.037W
The earth connection is compulsory
KH1510F / KH2015F / KH1613F / KH1520F

INSTALLATION

1) Check that the oil level is always over the
dipstick mark (A).
2) Connect the high pressure hose to the
outlet connection (B).
3) Connect the water supply pipe (diameter
not lower than 14 mm) to the pump inlet
connection (C). Make sure that the
suction filter of the suction hose
connection is always clean.
filter causes a bad water supply
and consequently a bad pump
operation with the inevitable risk of
rapid wearing out and breakage of
internal mechanisms.
WARNING
25
The dirty