USE & MAINTENANCE
Functions
I Shower blowpipe (pos. A)
located in the upper part, creates a generous rainfall jet.
I Vertical hydromassage (pos. B and C)
equipped with simultaneous water jets (2 upper nozzles and 2
lower), which are emitted from the nozzles on the wall panel.
Jets can be tilted in four directions, by pressing the nozzle and
moving it to the required position.
You can also change the form of the jet, using the tabs at the
centre of the nozzle.
I Shower head (pos. D, see "Use of functions")
Use of functions
GENERAL NOTES:
Never use water at a temperature of over 60 °C, to pre-
vent damage to the plumbing circuit.
NOTE: It is also possible to use two functions at the same time.
Just position the diverter dial half way between the t-
wo functions. If, for example, you wish to use all the
jets of the vertical hydromassage at the same time, y-
ou must turn the dial to the position between the sym-
bols (B) and (C); naturally, there will be a drop in the
water flow rate of the single jets.
Before you use any function, you should adjust the water tem-
perature to the value you want by doing the following:
I Turn the dial (M) so that the notch matches up with the cho-
sen value. The knob is provided with a safety lock that fixes the
temperature at 38°C; to select higher temperatures, push the
button (P).
I If you wish to try the water temperature, turn the diverter di-
al (G) to the "showerhead" (A) position and turn the stop tap (R)
to let water come out.
I Once the required water temperature has been reached, turn
the dial (G) to the position that indicates the function you want
to use
Remember to turn off the stop tap every time after use (R).
If temperatures above 38 °C have been selected, it is
advisable to turn back the thermostatic mixer dial to the
position before the safety lock.
A
In the event of difficulty...
PROBLEM / solution
WATER IS NOT SUPPLIED FROM VARIOUS FUNCTIONS
(SHOWERHEAD, VERTICAL HYDROMASSAGE, ETC.).
• Turn on the mixer tap.
THE SHOWERHEAD PROVIDES INADEQUATE PRESSURE
• Clean the filter situated between the flexible hose and the
shower head.
LITTLE WATER IS SUPPLIED FROM ALL FUNCTIONS
• Check that the installer has complied with the pressure/ca-
pacity specifications on the technical pre-installation data
sheet.
• Check that the thermostatic valve filter is not blocked with dirt
and/or lime scale.
• Check that the filters on the lower part of the panel are not
clogged with dirt and/or lime scale.
TH E HYD ROMASSAG E PROVI D E S I NAD EQUATE
PRESSURE
• Clean the nozzles. If this does not work, contact the Jacuzzi
Service Centre to check the pressure and the water system
capacity.
DIFFICULT TO ADJUST THE WATER TEMPERATURE
(MIXING)
• Check that the pressure values of the system (operating) for
hot and cold water are well-balanced. If the values are dif-
ferent, it is advisable to contact your plumber.
29
B
C
D
R
38°
G
P
M
®