Special Messages, Difficulties - De Dietrich DTI1089V Manual De Instalació Y Utilización

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

4 / SPECIAL MESSAGES, DIFFICULTIES

•On first use
A special lamp appears.
Your installation blows a fuse.
Only one side works.
The hob produces an odour dur-
ing the first cooking sessions.
•On switching on
YOU OBSERVE THAT:
The hob does not operate and
the indicator lights on the con-
trol panel do not light up.
The hob is not working and
another message is displayed.
The hob does not function, the
information
is displayed.
•While in use
YOU OBSERVE THAT:
The hob has stopped operating and is
beeping approximately every 10 sec-
onds and a
or F7 is displayed.
A series of small
played.
After turning on a heating zone, the
indicator lights on the control panel
continue to flash.
The saucepans make noise during
cooking.
Your hob makes a clicking sound dur-
ing cooking.
The fan continues to function a few min-
utes after your hob is turned off.
After turning on a heating zone, the
indicator lights on the control panel
remain steady but the cookware is not
heated.
POSSIBLE CAUSES:
Working normally.
The electrical connection of
your hob is incorrect.
New appliance.
POSSIBLE CAUSES:
The machine is not connected to
the power source. The power
source or connection is defective.
The electronic board is func-
tioning poorly.
The hob is locked
POSSIBLE CAUSES:
There was an overflow or an
object is in contact with the
control panel.
The electronic boards heated
or F7 is dis-
up.
The cookware used is not suit-
able for induction or is less
than 12 cm in diameter (10 cm
on a 16 cm area).
This is normal with some
types of cookware. This is
caused by the transfer of
energy from the hob to the
cookware.
Cooling of the electronic com-
ponents.
Working normally.
The cookware used is not
suitable for use with induc-
tion.
13
WHAT SHOULD YOU DO?
Nothing, the light disappears
after 30 seconds.
Check that it is set up
properly.
See
the
"Electrical
Connection" section.
Nothing. The smell will dis-
appear after several uses.
WHAT SHOULD YOU DO?
Inspect the electrical cir-
cuit breaker and fuses.
Call
the
After-Sales
Service Department.
See chapter on using the
child safety system
WHAT SHOULD YOU DO?
Clean the hob or remove the
object, then begin cooking
again.
See "Inserting" section.
See section on cookware for
induction.
Nothing. There is no risk, nei-
ther to your hob nor to your
cookware.
Nothing.
See section on cookware for
induction.
EN
Tabla de contenido
loading

Este manual también es adecuado para:

Dti1089ve

Tabla de contenido