Warnings; Cooking Guidelines; Timer; Countdown Timer - Siemens ER6 PT Serie Instrucciones De Uso

To deactivate the childproof lock:
Press the main switch for a few seconds. The main switch
indicator lights up. Now the hob can be switched on normally.

Warnings

This appliance will not function if it is not connected to the
mains or if the electricity supply is cut off.
It is normal to hear a soft whistling noise while the burner is
operating.
When first used, it is normal for the burner to give off odours.
This does not pose any risk and does not indicate a
malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by the
presence of dust in the atmosphere, spilt liquids, etc.
If the burner flames are accidentally blown out, switch off the
burner operating control knob and do not try to relight it for at
least 1 minute.
A few seconds after the burner is switched off, a sound (thud)
will be produced. This is not a fault - this means that the safety
device is no longer operating.
Keep the burner as clean as possible. If the ignition sparkers
are dirty they will not light properly. Clean them periodically

Timer

The timer can be used in two ways:
As a countdown timer.
■
To programme the automatic off of up to two burners.
■

Countdown timer

The countdown timer can be used to time periods up to 99
minutes. This is independent of other services. It can be
programmed even when the hob is switched off. This function
does not switch off any burner.
It is programmed as follows
Touch the symbol once. The
0
1.
time programming indicator
Touch the - or + symbol in the following five seconds to
2.
programme the required time.
The countdown begins in a few seconds.
The time programming indicator always displays the time
remaining for the first programme to finish.
When the programmed time has elapsed
A beep sounds for 30 seconds. The time programming
indicator is displayed.
‹‹
When any symbol is pressed the indicators go out and the
beep stops.
Change the programmed time
Touch the symbol and change the time using - or + in the
0
following 5 seconds. The new programmed time will begin after
a few seconds.
To cancel the programme
Touch the symbol and change the time to
0
+ symbols. The indicator disappears following a few seconds or
displays the time remaining for the following programme.
Note: The countdown timer does not continue after a power
failure.
indicator lights up. The
Q
is displayed.
‹‹
using the - or
‹‹
using a small non-wire brush. Bear in mind that the ignition
sparkers must not suffer any serious impacts.

Cooking guidelines

Burner Very high - High
Wok burner Boiling, steam-
ing, griddling,
toasting, paellas,
Asian food (wok).
Rapid burner Escalopes,
steaks, ome-
lettes, frying
Semi-rapid Steamed pota-
burner toes, fresh vege-
tables, vegetable
stews, pasta
Auxiliary Cooking: casse-
burner roles, rice pud-
ding, caramel
Programming a burner to switch off
automatically
Introduce a cooking time for the required burner. The burner
turns off automatically when the programmed time is reached.
Up to two burners can be programmed at the same time.
It is programmed as follows
The burner must be on.
Touch the symbol twice. The indicators display the
0
1.
settings of the burners of their hob for one second. Select the
desired burner by touching the
Touch the - or + symbol in the following five seconds to
2.
programme the required time.
The programme will start after a few seconds or when another
burner is selected.
This sequence may be used to programme any burner on the
hob.
The time programming indicator displays the time remaining for
the first programme to finish. The burner indicator
corresponding to the time lights up. The dimmed indicators
correspond to other programmes that are in progress. Touch
the 0 symbol to check all of the programmed times.
When the programmed time has elapsed
The burner goes out. A beep sounds for 30 seconds. The time
programming indicator ‹‹
flash successively. Then, when any symbol is pressed, the
indicators go out and the beep stops.
Turn the control knob of the burners switched off by the timer to
the 0 setting.
Change the programmed time
Touch the
0
symbol, select the burner and change the time
using the - or + in the following 5 seconds. The new
programmed time will begin after a few seconds.
Cancel the programme
Touch the 0 symbol, select the burner and change the time to
‹‹ using the - or + symbols. The indicator disappears following
a few seconds or displays the time remaining for the following
programme.
Medium Low
Reheating and keeping
things hot: cooked and pre-
cooked dishes
Rice, white Steaming:
sauce, ragout fish, vegeta-
bles
Reheating, keeping things
hot and making tasty casse-
roles
Defrosting Melting: but-
and slow ter, choco-
cooking: veg- late, jelly
etables, fruit
and frozen
products
symbol.
0
.
is displayed. The burner indicators
15