System Code; System Code Entering - Hiltron security XR Serie Manual Para El Usuario

security
3.1.4

System Code

LED lit
LED blinking
During this function, "SENSORI" (Sensors) LED is lit, "ALLARME" (Alarm) LED blinks, and
the Zones 1, 2 and 3 LEDs blink.This function allows to program and to display the System
Code of Central Unit; each devices connected to the Central Unit must have the same code.
The System Code consists of 18bit which identify all system, because it is integrated in the
digital informations transmitted by different devices. This to exclude the informations derived
from others systems, in example when they are installed nearby.
Use the following pattern to write the Code with a random sequence of "0" and "1".
HINT: the System Code can't be composed only by "0" or "1".

3.1.4.1 System Code Entering

To enter in System Code Entering mode, press "ESCLUSIONE"
!
(Exclusion) Zone 3 button; Zones 1, 2 and 4 LEDs turn off, and Zone
3 LED turn on.
Press the following buttons, to enter the 18 values System Code:
!
- "ESCLUSIONE" (Exclusion) Zone 1 button to enter "1".
- "ESCLUSIONE" (Exclusion) Zone 2 button to enter "0".
Whenever you press the button to enter a value, the LED blinks.
At the end of entering, the Central Unit utters 2 "BEEPs" and it memorize the new
code; if you have entered only "0" or "1", the XR500 utters 4 "BEEPs" and returns to previous
code.
antifurtoriginale.it
ST/BY
RETE
POWER
ASSENZA RETE MAIN POWER
INSERITO
ARMED
ALLARME
ALARM
FLASH:
MEMORIA ALLARME
MEMORY ALARM
XR500
System Code
24h
CENTRALE
CENTRAL
SENSORI
STATO ZONE
SENSORS
ZONE STATE
SIRENE
SIRENS
RX / TX MEMORIA
ALLARME
ALARM
MEMORY
Programming
ZONE CONTROL
ON FLASH
ZONA APERTA ZONA ESCLUSA
ZONE ESCLUSED
ZONE OPENED
OFF LAMP: ZONA
ZONA CHIUSA ALLARMATA Zone alarmed
CLOSED ZONE
E X C L U S I O N
"1" "0"
39