Setting The Dip Switch; Turning On The Power - Fujitsu UTY-DMMUM Manual De Instalación

(6) Attach the front case.
• Insert after adjusting upper part of front case.
• When insert the front case, do not pinch the cable.
Front case
Good No good
• Insert the upper case firmly. If improperly attached,
it will cause the upper case to fall off.

5.4. Setting the DIP switch

• Install the remote controller cables so as not to be direct
touched with your hand.
• Do not touch the remote controller PC board and PC
board parts directly with your hands.
Set DIP switch No. 1 to ON to enable the memory backup of
time information.
• Memory backup setting
If the DIP switch No. 1 is not set to ON, the current time
information will be lost if there is a power failure.
* Registered information, such as that for the internal unit,
is not erased even if the DIP switch is turned off.
DIP Switch
En-6
9380222002-02_IM.indb 6
Click!
No good No good
CAUTION
CAUTION
ON
OFF
1 2 3 4 5 6
Front case
(back side)
Switch state
No.
OFF
1 Invalidity Validity
DIP
2
switch
3
4
5
6

6. TURNING ON THE POWER

CAUTION
• Recheck the wiring. Incorrect wiring will cause trouble.
For setting and operating of the Central remote controller, refer
to the separate operating manual.
Detail
ON
Memory backup
setting
* Set to ON to use
batteries for the
memory backup.
If batteries are not
used, all of the
settings stored in
memory will be
deleted if there is a
power failure.
Cannot be used.
(Do not change)
Cannot be used.
(Do not change)
Cannot be used.
(Do not change)
Cannot be used.
(Do not change)
Cannot be used.
(Do not change)
( Factory setting)
24/08/2010 10:22:35