Waring Commercial XTREME MX Serie Manual De Instrucciones página 4

6. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
7. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
8. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
9. To turn unit off, press STANDBY
MX ELECTRONIC TOUCHPAD SWITCHES WITH TIMER
1. Before starting, make sure that the blender is
unplugged and container is not positioned on
the blender.
2. Put ingredients into container and cover it.
Do not fill above MAX fill line.
3. Place container on blender base. Be sure container
is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
4. This blender is equipped with an electronic membrane keypad. The
keypad has a main power STANDBY
and PULSE
and down
5. Press the STANDBY
illuminate. The electronic timer will indicate 10 seconds (default). Press
the up or down
timer will indicate run time in 5-second intervals up to a maximum of
30 seconds. After the desired time is set, press HI
blender. The timer will count down to 0 in 1-second intervals and blender
will shut off. Pressing the PULSE
STANDBY
regardless of time left on timer.
NOTE: If you want to increase or decrease time while timer is counting
down, press up
in 5-second intervals.
6. If the blender is not used for 5 seconds, the timer function will turn off
and return to manual mode. To reactivate timer, press up
arrows. When using the electronic timer again, the initial time will be the
last time set. Note: If unit has been turned off or unplugged, the timer
will default back to 10 seconds.
7. For continuous operation, press either LO or HI
finished blending, press STOP
the PULSE
is released.
NOTE: Your MX Electronic Blender uses a Slow Start
pressing HI , the unit will start in the LO
then switch to HI
ingredients in container.
buttons and a 30-second countdown timer with up
arrows to set time.
button to turn on the blender. Green LED will
arrow to set the desired time. The electronic
button will override the timer and the blender will stop
or down
button. Motor will run on HI
speed. This allows for a more even blending of
button. Green LED light will go off.
button, plus HI
button, the STOP
arrows. Time will increase or decrease
. For momentary operation, press
speed until the button
speed for 2 seconds and
4
, LO , STOP
or LO to start the
button or the
or down
button. When
feature. When
™