Eccentric Screws; Sawing (Without The Guide Rail); Sawing (With The Guide Rail) - Parkside PTSS 1200 C2 Traducción Del Manual De Instrucciones Original

NOTE
► The guide rails
(black rubber lip). The splinter guard must be
adjusted before making the first cut. Place the
guide rail onto a workpiece. Set a cutting
depth of approx. 10 mm. Switch the circular
saw on and push it gently and evenly in the
cutting direction.

Eccentric screws

The eccentric screws
adjustment of the fit of the base plate
guide rail .
♦ Tighten the eccentric screws
play between the circular saw and the guide
rails .

Sawing (without the guide rail)

Right-angled sawing
♦ Hold the machine with both hands firmly on
the handles and
♦ Switch on the appliance as described in
"Switching on and off".
♦ Place the appliance with the front part of the
base plate on the workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Mitre angles up to 45°
♦ Adjust the cutting angle as described.
♦ Hold the machine with both hands firmly on
the handles and
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance with
the front part of the base plate
piece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
│ GB │ MT
■ 52
have a splinter guard
are intended for the
on the
to reduce the
.
.
on the work-
Plunge cuts
♦ When making a "plunge cut" that is not at right
angles, secure the base plate of the saw to
prevent any lateral movement. Lateral movement
can cause the saw blade to jam, thus causing a
kickback.
♦ Adjust the desired cutting depth as described
above.
♦ Place the appliance onto the workpiece.
♦ Avoid a kickback and place the rear edge
against a stop.
(reference is made to this in the section "Plunge
cutting using the guide rail").
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on
the handles and
NOTE
► The cutting width marking
the blade guard shows the front and rear
cutting point of a 165 mm saw blade at
maximum cutting depth. This applies both for
plunge cuts using the guide rail
plunge cuts without using the guide rail

Sawing (with the guide rail)

Right-angled sawing with the guide rail
♦ Apply the guide rail
elements onto the workpiece.
♦ Place the appliance with the groove
the guide rail .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on
the handles and
and pivot it.
on the side of
and
.
with the foam rubber
onto
and pivot it.
PTSS 1200 C2