Idiomas disponibles
Idiomas disponibles
7. Hitch height determination:
With trailer leveled and on level ground measure from the ground to the bottom of the king pin box ("A" in Figure 7). Secondly
measure the height of the inside of the truck bed to the ground ("B" in Figure 7). Determine the amount of clearance over the
side rails ( "C" and "D" in Figure 7).
** The 2" value is an estimate of suspension compression due to king pin weight of the trailer. This compression could range
between 1"-5" depending on the truck being used and the trailer being towed.
8. If a lube plate is to be used with a REESE
Products, Inc. offers this optional lube plate as part # 83001.
Connection for trailer wiring must be located at the side of the truck bed between the driver's
seat and the rear wheel to prevent operators from working between the truck and trailer.
Avoid putting any part of your body under the trailer or between the truck and trailer.
Unexpected or accidental movement of the truck or the trailer can cause serious injury or death
If you must place any part of your body under the trailer or between the truck and trailer you
MUST perform ALL of the following steps:
Check that the truck transmission is in park
Check that the emergency brake is on
Block in front of and behind all trailer tires
Check that the trailer landing gear are resting on firm ground
30126N
05/23/14
REV F
Hitch Height = A – B + 2" **
D – C + 2" > 6"
B
™
Fifth Wheel it must be at least 12" in diameter. Cequent Performance
®
Elite
WARNING:
PCN3694
©2011, 2014 CEQUENT PERFORMANCE PRODUCTS, INC.
C
D
*MEASURED WITH TRAILER LEVEL,
A
Figure 7
ON LEVEL GROUND
PRINTED IN MEXICO
4
