Pigtail Removal And Installation; Proper Tool Selection - RIDGID K-6200 Manual De Instrucciones

K-6200 Drain Cleaning Machine
2. Disconnect the original cable from the pigtail sec-
tion. Secure the initial cable to keep it from falling
into the drain.
3. Remove the AUTOFEED assembly as described in
Steps 2 – 3 of Drum Assembly Removal section.
4. Remove the drum assembly described in Step 4 of
Drum Assembly Removal section.
5. Place second drum assembly onto the machine by
following instructions in Step 2 of Drum Assembly
In stal lation section.
6. Attach AUTOFEED by sliding the assembly onto the
cable. Slide assembly onto front support and tighten
the two T-handle mounting knobs.
7. Attach the cable from the extra drum to the cable in
the drain.
NOTE! Be sure all cable and cutter is spinning in drain
before feeding in more cable.

Pigtail Removal and Installation

1. Set the kickstand.
2. Remove all cable from the drum except the pigtail.
3. Remove the AUTOFEED assembly and main drum.
4. Remove the outer retaining clip from the guide tube
shaft (Figure 13). Slide bearing off the shaft.
Figure 13 – Remove Retaining Ring and Inner Drum
5. Remove retaining ring holding inner drum in place
and remove inner drum.
12
Find Quality Products Online at:
Figure 14 – Removing Pigtail Anchoring Bolt
10. Place the drum assembly into the machine by fol-

Proper Tool Selection

A good rule of thumb is to make the first pass with either
a grease cutter or blade cutter that is 2" smaller than the
drain size. For additional passes, larger tools may be
used. However, tools should generally be at least 1"
smaller than the drain size. Use a full size blade on the
final pass.
The style of tool is determined by the nature of the job and
is left to the discretion of the operator.
Flexible leaders should be used to negotiate bends and
traps in lines.
GlobalTestSupply
www.
6. Remove the bolt anchoring the pigtail. It is located on
the back of the drum (Figure 14).
7. Remove the pigtail from the guide tube and drum
and insert new pigtail into the drum.
8. Align hole in pigtail with the hole in the back of the
drum. Insert bolt, washers and nut and tighten se-
curely. Push the remainder of the pigtail into drum.
9. Push the end of the pigtail through guide tube. Install
inner drum and bearing by reversing Steps 4 and 5.
lowing instructions in Step 2 of Drum Assembly In -
stallation section.
.com
[email protected]