Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FOR/OFF/REV switch in FOR (forward) position and
follow normal operating procedure.
Never operate this machine in REV (reverse) for any
other purpose. Operating in reverse can damage a cable
and cause serious injury.
Loading The Machine On Vehicle
Tip machine backwards and rest handles on truck bed.
Lift up on front of machine and slide onto truck.
Use proper lifting technique – lift with
WARNING
your legs, not your back!!
NOTE! Take care not to damage electrical cord or air
foot switch hose.
Drum Removal & Installation Procedure
WARNING
Make sure FOR/OFF/REV switch is in OFF position
and machine is unplugged from power source.
1. Push down on motor table handle to release belt
tension and slip belt off drum. (Figure 9)
" wrench to remove bolt that fastens drum
2. Use
3
/
4
assembly to machine frame. (Figure 10)
Figure 9 – Release Belt Tension
K-750R
5
/
" Cage Machine
8
Figure 10 – Remove Bolt Which Fastens Drum Assembly
to Machine Frame
Figure 11 – Lift Drum From Mounting Position
3. Lay machine back so that it rests on handles. Grasp
drum with both hands and lift it out of its mounting
position on machine (Figure 11) .
To avoid back injury, be sure to bend your
CAUTION
knees and lift with your legs.
4. To install drum assembly, place it in its mount on
machine frame. Drum assembly should slide onto
shaft mounted on frame.
5. Carefully return machine to its upright position and
reverse Steps 1 through 5 to prepare machine for
operation.
Pigtail Removal and Installation
WARNING
FOR/OFF/REV switch should be OFF and machine is
unplugged before removing or installing pigtail.
1. Remove all cable from the drum except the pigtail.
9
Capítulos
Tabla de contenido
