Connecting The Base Connector Rear Panel And The Base Connector Front Panel - Panasonic AW-PH360L Manual De Operación

Connections
$ Connecting the base connector rear panel and the base
connector front panel
5 1394 connector
This is for controlling the convertible
camera, in which an IEEE1394 card has
been installed, and the pan/tilt head.
As the connecting cable, use an
IEEE1394 cable.
Pin No.
1
2
3
4
5
6
<Note>
OThis unit cannot be controlled directly
using an IEEE1394 card. A convertible
camera containing the plugged-in
IEEE1394 card is needed.
6 CONTROL IN IP/RP connector
This is for camera / pan/tilt head control
signals.
Connect this to the PAN/TILT
CONTROL OUT connector on the
controllers AW-RP301/AW-RP305/
AW-RP501/AW-RP505, or multiport hub
AW-HB505, CONTROL OUT TO
PAN/TILT HEAD connector on the
controller AW-RP605A, or CONTROL
OUT TO PAN/TILT connector on the
controller AW-RP400.
Use a 10BASE-T straight cable (UTP
category 5) for the connecting cable.
<Notes>
ODepending on the controller to be used,
it may be necessary to change the
switch positions. For details on how to
do this, refer to the section on "Controller
selection switch settings" under
"Installation" (page 9).
Signal
DC 12V
GND
TPB 2
TPB
TPA 2
TPA
- 23 (E) -
OFor your safety, connect to an Ethernet
network which does not exceed the
voltage limit of the Ethernet connector.
7 Y OUT connector
This is for camera video signal output.
Connect this to the Y IN connector on
the controller or to a monitor, etc.
Use a coaxial cable (BBC No.PSF1/2M,
BELDEN 8281) for the connecting
cable.
8 Pr/SDI OUT connector
This is for camera video signal output.
Connect this to the Pr IN connector on
the controller or to a monitor, etc.
SDI signals can be output when an SDI
card (AW-PB504, etc.) is installed in the
convertible camera for use.
Use a coaxial cable (BBC No.PSF1/2M,
BELDEN 8281) for the connecting
cable.
<Note>
OTo switch from Pr to SDI or vice versa, it
is necessary to change the switch
positions. For details on how to do this,
refer to the section on "Transmission
signal selection setting" under
"Installation" (page 10).