Mounting The Camera - Panasonic AW-PH360L Manual De Operación

Installation

$ Mounting the camera

The pan/tilt head's camera mounting section has a mechanism for maintaining the
camera's balance that moves the camera mounting plate using a guide roller as a fulcrum.
Use the following recommended lenses corresponding to the camera to be used.
(Before mounting a lens other than recommended lenses, consult with your dealer.)
1. Change the position of guide pin A and/or the camera mounting screws in accordance
with the following installation of the pan/tilt head before mounting the camera.
2. Adjust the balance by loosening the guide screws and moving the camera mounting plate.
3. Upon confirming the position where the balance is maintained, firmly tighten the guide
screws. If the balance cannot be maintained, change the position of guide pin B or the
positions of the guide screws, and adjust the balance again.
<Note>
O The guide roller is fixed in place. Do not remove the guide roller screw.
<Stand-alone installation>
<Suspended installation>
(The installation work must be performed by your dealer without fail.)
Camera mounting screws
Guide screw
A
Guide pin
Guide screw
- 13 (E) -
Camera mounting plate
Guide screw
B
Guide pin
Change the position of the camera mounting
screws and the guide pin
installation.
Camera mounting plate
Guide screw
B
Guide pin
A
Guide pin
Guide roller
A
to change the
Camera mounting
screws
Guide roller