ResMed S9 Serie Guia De Informacion página 5

Problem/possible cause
A non-ResMed power supply unit is
connected to the device.
The power supply unit is being covered
by bedding.
Displays error message:
Air tubing is blocked.
The following message is displayed on the LCD after you try to update settings or copy data
Card error, please remove SD card and contact service provider
to the SD card:
SD card is not inserted correctly.
You may have removed the SD card
before settings were copied to the S9
device.
The following message is NOT displayed on the LCD after you try to update the settings using
Settings updated successfully, press any key
the SD card:
The settings were not updated.
Water splashing on your face from the H5i
The water tub is overfilled.
Condensation is forming in the air tube
and mask.
Leaking water tub
The water tub may be damaged or
cracked.
The cleanable water tub is not
assembled correctly.
Solution
Remove the power supply unit and replace with a ResMed
power supply unit.
Make sure that the power supply unit is free from bedding,
clothes or other objects that could cover it.
Tube blocked, please check your tube
Check your air tubing and remove any blockages.
Disconnect the power cord and then reconnect it to restart
the device.
Ensure that the SD card is inserted correctly.
Reinsert the SD card and wait for the Home screen or the
Settings updated successfully, press any key
"
to appear on the LCD.
Note: This message only appears once. If you re-insert the
SD card after you have updated your settings, the message
will not be re-displayed.
Contact your clinician/service provider immediately.
Check that the water level is below the maximum water
level mark.
Turn the H5i or relative humidity setting down via the
menu.
Contact your service provider for a replacement.
Check for damage and reassemble the cleanable water tub
correctly.
" message
5
English