Led Light - Panasonic EY46A5 Manual De Instrucciones

2. For continuous operation, press the
front of the power switch to lock it.
[Fig.5 ]
• To stop the tool, press the rear of the
power switch, then it returns to the
"OFF" position. [Fig.6]

LED light

Illuminates while depressing the power
switch.
CAUTION
• Do not use it as a substitute for a regular
fl ashlight, since it does not have enough
brightness.
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or
performance of procedures other than
those specifi ed herein may result in
hazardous radiation exposure.
Frequency adjustment
• By turning the frequency adjustment dial
(E), the frequency can be switched freely
between 6000 min
-1
• There are 1 to 6 dials, and the frequency
increases as the number increases.
• Set the frequency by turning the dial
according to the work purpose.
• Turn the frequency adjustment dial to
adjust the frequency according to the
work application.
Also, be sure to check that the frequency
can be adjusted by turning the frequency
adjustment dial with the switch on before
starting work.
Indicator lamp for On lock
start prevention function
This unit will not start when the battery
pack is inserted with the switch at the
"ON" position (switch lever at "ON").
The warning lamp will fl ash at this time to
indicate that the "On lock start prevention
function" has operated. [Fig.9]
• Press the switch to the "OFF" position
(switch lever at "OFF") and then press it
and 20000 min .
-1
back to the "ON" position (switch lever at
"ON") to start this unit. [Fig.9]
NOTE:
• If the battery level is extremely low, the
warning lamp may not blink.
Overheat warning lamp
Off
(normal
operation)
To protect the battery, be sure to note the
following when carrying out this operation.
• If the battery becomes hot, the protection
function will be activated and the motor
or battery will stop operating. The
overheat warning lamp on the control
panel illuminates or fl ashes when this
feature is active.
• If the overheating protection feature
activates, allow the tool to cool
thoroughly (at least 30 minutes). The tool
is ready for use when the overheat
warning lamp goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to
activate repeatedly.
• If the tool is operated continuously under
high-load conditions or if it is used in
hot-temperature conditions (such as
during summer), the overheating
protection feature may activate
frequently.
• If the tool is used in cold-temperature
conditions (such as during winter) or if it
is frequently stopped during use, the
overheating protection feature may not
activate.
• The performance of the EY9L42
deteriorates signifi cantly at and below
10 °C due to work conditions and other
factors.
- 11 -
Flashing: Overheat
Indicates operation has
been halted due to
battery overheating.
EN
DE
FR
IT
NL
ES
DA
SV
NO
FI
TR
PL
CS
HU