Led Light; Battery Level Indicator; Overheat Warning - Panasonic EY76A1 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49

LED Light

Press the light button and set illumination
condition.
Illuminated
Illuminates by pressing button.
The light turns off when the tool
has not been used for more
than 5 minutes or just after
attaching the battery pack.
Depress the trigger switch and
operate the tool once.
Interlocking trigger
Illuminates while depressing the
trigger switch.
Off
CAUTION:
Do not use it as a substitute for a
regular flashlight, since it does not have
enough brightness.
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.

Overheat warning

Off
Illuminated:
(normal
Overheat
operation)
(motor)
Indicates operation has been halted due to
motor or battery overheating.
• If the overheating protection feature
activates, allow the tool to cool thorough-
ly (at least 30 minutes). The tool is ready
for use when the overheat warning lamp
goes out.
• Avoid using the tool in a way that causes
the overheating protection feature to
activate repeatedly.
• The performance of the EY9L42 deterio-

Battery Level Indicator

Press the battery level button. It shifts to
Impact power mode when release the
button.
Flashing:
Overheat
(battery)
[Battery Pack]
For Appropriate Use of
Battery Pack [Fig.7]
• For optimum battery life, store the Li-ion
• When operating the battery pack, make
- 11 -
rates significantly at and below 10°C due
to work conditions and other factors.
NOTE:
The indicator will not show the battery
level even the button is pressed in the
following cases.
• The main unit is powered off.
• Just after attaching the battery pack
• The main unit or battery level button is
not operated for approx. five minutes.
Press the battery level button again
after depressing the trigger switch.
Indicator
3 lamps
illuminated
2 lamps
illuminated
One lamp
illuminated
3 lamps
flashing
battery pack following use without
charging it.
sure the work place is well ventilated.
EN
Battery status
Charged
enough
Approx. 60%
remaining
Battery level is
low.
Empty
Tabla de contenido
loading

Tabla de contenido