Indication Of The Leds And Use Of The Remote Hmi; Indication Of The Leds - WEG ADW300 Manual Del Usuario

4 INDICATION OF THE LEDS AND USE OF THE REMOTE HMI

4.1 INDICATION OF THE LEDS

The ADW300 has two leds for status indication (H1 - green) and fault indication (H2 - red).
4.1 on page 15 shows the location of the leds and fan in the product:
Figure 4.1: Location of the leds and fan in the ADW300
Indications of the green led H1 - Status: this led indicates that the inverter is working properly.
a) Always on: when the inverter is energized and not in a fault condition.
b) Flashing quickly (1 second on and 1 second off): when the motor is running.
c) Off: when the inverter is in a fault condition or the power supply is disconnected.
Indications of the red led H2 - Faults: this led indicates when the inverter is in a fault condition.
a) Off: inverter is working properly or the power supply is disconnected.
b) Flashing: inverter is in a fault condition. Led H2 flashes according to the fault occurred in the
inverter. Table 4.1 on page 16
Green led H1 for
status indication
indicates the faults according to the number of flashes of led H2.
Keypad (HMI) and Basic Programming
Red led H2 for
fault indication
Figure
Fan
ADW300 | 15