Final Installation Checklist; Operation Checklist - GE JCAS745 Manual De Uso

11

FINAL INSTALLATION CHECKLIST

• Check to make sure the circuit breaker is closed (RESET)
or the circuit are replaced.
• Be sure power is in service to the building.
• Note (on some models): If the clock flashes "bad" and
then "LinE" with a loud tone, the neutral connection to
the range is miswired. Check the terminal block connec-
tions and/or house wiring to correct.
• Check to be sure that all packing materials and tape
have been removed. This will include tape on metal panel
under control knobs (if applicable), adhesive tape, wire
ties, cardboard and protective plastic. Failure to remove
these materials could result in damage to the appliance
once the appliance has been turned on and surfaces
have heated.
• Check to make sure that the rear leveling leg is fully in-
serted into the Anti-Tip bracket and that the bracket is
securely installed.
Installation Instructions
12

OPERATION CHECKLIST

• Turn on one of the surface to observe that the element
glows within 60 seconds. Turn the unit off when glow is
detected. If the glow is not detected within the time limit,
recheck the range wiring connections. If change is re-
quired, retest again. If no change is required, have build-
ing wiring checked for proper connections and voltage.
• Check to make sure the Clock (on models so equipped)
display is energized. If a series of horizontal red lines ap-
pear in the display, disconnect power immediately. Re-
check the range wiring connections. IF change is made
to connections, retest again. If no change is required,
have building wiring checked for proper connections and
voltage. It is recommended that the clock be changed if
the red lines appear.
• Be sure all range controls are in the OFF position before
leaving the range.
85