GE JCAS745 Manual De Uso página 83

ELECTRICAL CONNECTIONS (CONT.)
6 3-WIRE CONDUIT INSTALLATION
A
Loosen the 3 lower terminal screws from the terminal
block. Insert the center bare wire (white/ neutral) tip
through the bottom center terminal block opening. On cer-
tain models, the wire will need to be inserted through the
ground strap opening and then into the bottom center
block opening. Insert the two side bare wire tips into the
lower left and the lower right terminal block openings.
Tighten the screws until the wire is firmly secure (approxi-
mately 20 inch-lbs.).
NOTE: ALUMINUM WIRING:
Aluminum building wire may be used but it must be rated
for the correct amperage and voltage to make connection.
Connect wires according to this Step 6 or Step 7 depend-
ing on number of wires.
Terminal
block
Wire tips
Bracket
Wire used, location and enclosure of splices, etc., must
conform to good wiring practices and local codes.
B
Skip to Step 8 and proceed with the installation.
Installation Instructions
Conduit
7 4-WIRE CONDUIT INSTALLATION
A
Loosen the three lower terminal screws from the terminal
block. Remove the ground screw and ground plate and re-
tain them.
Cut and discard the ground strap.
DO NOT DISCARD ANY SCREWS.
B
Insert the ground bare wire tip between the range frame
and the ground plate (removed earlier) and secure it in
place with the ground screw (removed earlier). Insert the
bare wire (white/neutral) tip through the bottom center of
the terminal block opening. Insert the two side bare wire
tips into the lower left and the lower right terminal block
openings. Tighten the screws until the wire is firmly secure
(approximately 20 inch-lbs.).
Wire used, location and enclosure of splices, etc., must
conform to good wiring practices and local codes.
Before
Terminal
block
Ground strap
After
Terminal
block
Ground
screw
C
Proceed to Step 8.
8 REPLACE THE WIRE COVER
Replace the wire cover on the range back by sliding its two
lower retaining tabs into the slots and replacing the screw
removed earlier. Make sure that no wires are pinched be-
tween the cover and the range back.
Ground strap
or
Neutral
terminal
Neutral terminal
Ground
plate
(grounding
to range)
83