Assembly; Battery Cable Connection - Generac GP Serie Manual Del Usuario

Service Warranty
Emissions Warranty
Hardware Bag
Cotter Pin (F)
Spacer (G)
Locking Flange Nut (H)
Hex Head Bolt (J)
Lock Washer (K)
Flat Washer (L)
Capscrew (5/16 x 1) (M)
Capscrew (5/16 x 2-1/2) (N)
3. Call Generac Customer Service 1-888-
GENERAC (1-888-436-3722) with the unit
model and serial number for any missing
carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.

Assembly

WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Call Generac Customer Service at 1-888-
GENERAC (1-888-436-3722) for any assem-
bly issues or concerns. Please have model
and serial number available.
The following tools are required to install the
accessory kit.
• Needle nose pliers
• 9/16" and 1/2" socket and ratchet
• 1/2" wrench
NOTE: The wheels are not intended for over-
the-road use.
See Figure 2-10.
Install wheels as follows:
1. Slide axle (D) through the flat washer (L)
spacer (G), wheel (B), and axle bracket
assembly (E) on frame.
2. Insert cotter pin (F) through axle (D). Bend
tabs (of cotter pins) outward to lock into
place.
3. Install locking flange nut (H).
Install frame foot assembly as follows:
1. Slide hex head bolts (J) through holes in
frame rail.
2. Slide frame foot (C) onto hex head bolts
(J). Install locking flange nut (H).
3. Slide capscrew (M) through frame foot
assembly (C). Install lock washer (K), flat
washer (L) and locking flange nut (H).
Owner's Manual for Portable Generator
Install handle as follows:
1
1. Slide capscrew (N) through flat washer (L),
1
handle (A) and frame. Install flat washer
(L) and locking flange nut (H).
.
Qty.
2
2
N
10
6
2
8
2
4
Figure 2-10. Wheel & Handle Assembly

Battery Cable Connection

(000100a)
The battery shipped with the generator has
been provided fully charged. Caution must be
taken when connecting battery.
NOTE: A battery may lose some of it's charge
when not in use for prolonged periods of time.
Two 7/16" box wrenches are needed to con-
nect battery cables.
1. Cut tie wrap cable holding the RED and
BLACK battery cables to the stator.
2. See
cable (A) to battery Positive terminal (+).
Make sure connection is tight and slip rub-
ber boot over terminal.
3. Connect BLACK battery cable (B) to bat-
tery Negative terminal (–). Make sure con-
nection is tight.
4. Install battery post cover (included). See
Figure
H
L
L
A
C
H
CAUTION
Equipment damage. Do not make battery
connections in reverse. Doing so will result
in equipment damage.
Figure 2-11. Connect RED battery
2-11.
E
G
B
L
F
J
M
000925
D
L
K
(000167a)
9